|
Concrete Railroad Bridges in HO Scale Handcrafted in the USA |
 |
|
The Board-Formed Concrete Pier at left is based on a prototype found on the former GM&O Railroad in Mississippi. This Pier will fit most single track Through-Truss Bridges in HO scale.
This Pier (Model BP-8) is priced at $10.00 each. Measurements: 28 feet tall and 30 feet wide (at the top) in HO scale. Will support bridges up to 25 feet wide. The cap is a separate casting which may be omitted if desired. |
|
This pier has a pointed end which should be placed on the upstream side of the bridge. It acts to deflect water and floating debris. Shown at left is the BP-8 Bridge Pier supporting a BLMA Through-Truss bridge. Other bridges that will work are the Central Valley and Walthers single track through-truss spans.
|
|
The Board-Formed Concrete Pier at left is based on prototypes found on Santa Fe and Western Pacific Railroads. It will fit Deck Plate Girder Bridges in HO scale.
This Pier (BP-5) is priced at $10.00 each. Measurements: 27 feet tall and 20 feet wide (at the top) in HO scale. These Modern Bridge Piers at left and below are sized to fit HO scale Deck Plate Girder and Through Plate Girder Bridges. All four sizes are priced at $8.00 each. Measurements are: At left, 25 feet and 19.5 feet tall. Bottom left: 30 feet and 25 feet tall. Square end caps are 18 feet wide. Round end caps are 23 feet wide in HO scale.
At left, a Modern Round-End Capped Pier supports a Central Valley 72 foot TPG Bridge. Scaled from prototypical drawings, these modern piers are an ideal way to update your model railroad empire. Bridges not included with piers. |
